Traxxas Slash 4X4 Low-CG (Low Center of Gravity) Conversion Kit, 7421

Everything to convert your Slash 4X4
Performance-proven by the Slash 4X4 Ultimate and 1/10 Rally, the Traxxas Low-CG chassis is now available as a complete conversion kit for Slash 4X4. No matter where you want to race, on the track or off, you will experience superior handling and faster corner speed. The conversion kit includes all the parts and hardware required to convert one Slash 4X4 to the Low-CG configuration.

Performance Optimized
The Low-CG chassis holds the battery* and electronics* as deep in the chassis as possible to position weight low in the chassis. To prevent flex under load, the chassis is reinforced by integrated ribs that form a ridged triangulated structure. Underneath, the chassis is ultra-smooth to reduce drag and prevent snags whether you're blasting through whoops on the track or blazing trails in your backyard. The low-CG design dramatically increases corner speed and stability no matter where you drive.

Integrated Personal Transponder Mount
If your Slash 4X4 is destined for the track, the Low-CG chassis is ready to accept your personal transponder. Bosses integrated into the chassis make it easy to mount the transponder with two screws, no tape required. And of course, the transponder mounts up front, so it gets to the finish line faster!

• Complete kit, no additional parts required
• Lowers chassis one inch
• Over 50% lower battery position
• Low center of gravity enhances handling and increases cornering speed
• Integrated transponder mount
• Genuine Traxxas quality and precision

• Chassis
• Nerf bars (2)
• Front bulkhead
• Rear bulkhead
• Motor mount
• Motor plate
• Battery hold-down
• Front and rear hold-down retainers
• Servo horn
• Steering linkage
• Waterproof receiver box with o-ring seal
• Gear cover
• Wire retainer
• Complete installation hardware set