MENU
(Includes oversized bearings, carriers, & setscrews.
Fits all versions of the Traxxas Revo* and Slayer)
Fits all versions of the Traxxas Revo* and Slayer)
RPM Axle Carriers for the Traxxas Slayer, Revo, T-Maxx 2.5R, T-Maxx 3.3 & E-Maxx 16.8 have been painstakingly redesigned to improve the durability, strength, and reliability of these much-abused parts. Check out this laundry list of features built into each set of RPM Revo carriers:
Axle Carriers:
-
Stock replacement no modifications are needed to bolt them in.
-
Larger bearing bores accept RPM oversized bearings.
-
Included in each kit are two 15mm bearings and two 21mm bearings. The wall thickness around the pillow-balls has been increased by 40% - eliminating split walls!
-
More than 20% more material supports the pillow-balls, preventing them from pulling through.
-
Redesigned reinforcing rib supporting the tie rod mount.
-
Redesigned boot lock tabs making removal of the silicone boots easier.
-
Press-fit bearings in the carrier means reduced movement of the axle in the carrier.
Oversized Bearings:
-
Outer bearings are 6x15x5mm (stock is 6x12x4mm).
-
Inner bearings are 12x21x5mm (stock is 12x18x4mm).
-
Wider bearings create an additional 2mm of contact with the axle for smoother, longer running performance.
-
3mm. larger bearings have balls a full 33% larger than stock!
-
The load ratings of RPM oversized bearings are double that of stock bearings and more than triple the fatigue rating of stock bearings as well!
Pillow-Ball Setscrews:
-
Two-piece design uses aluminum and Delrin for the ultimate in holding power under extreme situations.
-
Our aluminum setscrews reduce movement of the pillow-balls in the carrier.
-
Our Delrin bushing caps have more than twice the contact area on the pillow-ball, keeping the pillow-balls locked in place at all times.
RPM Slayer, Revo, T-Maxx 2.5R, T-Maxx 3.3 & E-Maxx 16.8 axle carriers are sold with 1 left and 1 right axle carrier, 2 outer 15mm bearings, 2 inner 21mm bearings, 4 aluminum setscrews, 4 Delrin bushing caps, and detailed instructions to help install them on your truck. Replacement bearing sets (#80570) come with 2 inner 21mm bearings & 2 outer 15mm bearings.
*Tech Note: Due to increased material to support the pillow balls from pulling through the carrier, RPM Axle Carriers will not work in conjunction with Slayer / Revo 120-LT Long Travel rockers (Traxxas #5356). RPM Axle Carriers will not work on the E-Revo 2.0.
RPM Recommendations: To prolong the life of your bearings, RPM recommends the use of our #81170 Bearing Blaster. For accurate camber adjustments, please consider the use of our #70950 Monster Camber Gauge.
